Colour System; Input Signal Display; Input Level - Panasonic H-55LFV60U Operating Instructions Manual

■
[MPEG noise reduction]
Reduces block noise and mosquito noise on MPEG
videos.
[Off]:
Disables Noise Reduction.
[Min], [Mid], [Max]:
Sets strength of Noise Reduction.
■
[XGA mode]
This menu is displayed at PC IN and COMPONENT/
RGB IN inputs.
This unit supports XGA signals (1024 × 768, 1280 ×
768, 1366 × 768) having different aspect ratios and
sampling rates.
[Auto]:
Automatically detects the signal.
Switch the setting to suit the input signal for better
display depends on the angle of view or display
resolution condition.
Note
●
After making this setting, be sure to make each
adjustment (such as [Auto setup]) on the [Position]
menu as necessary. (see page 37)
■
[Signal range]
This menu is displayed at HDMI1, HDMI2 and DVI-D IN
inputs. Switches the dynamic range to match the signals
from the source connected to each terminal.
[Video(16-235)]:
If the input signal is the video range
Example: HDMI terminal output for DVD player
[Full(0-255)]:
If the input signal is full range
Example: HDMI terminal output for personal
computer
[Auto]:
Switches the dynamic range automatically between
[Video(16-235)] and [Full(0-255)] according to the
input signal.
Note
●
[Auto] can be selected when the HDMI signal input.
■

[Input level]

This menu is displayed at PC IN, COMPONENT/RGB IN
and VIDEO IN inputs.
Adjustment of parts which are extremely bright and hard
to see.
- 16 to + 16:
(Level low) - (Level high)
48
English
■
[3D Y/C filter]
Set this if the video looks unnatural at VIDEO IN input.
Set this to [On] normally.
Note
● Depending on the signalling system, this setting
may be less effective or may not be effective at all.
■

[Colour system]

Sets the colour system according to the signal method
at VIDEO IN input. Set this to [Auto] normally. This
automatically detects the input signal format.
[Auto], [PAL], [SECAM], [NTSC], [NTSC 4.43], [PAL
M], [PAL N]:
Set this to [Auto] when viewing PAL-60 videos.
When images are unstable
When the system is set to [Auto], images become
unstable in rare case under the condition that the
input signals are at low level or have many noises.
In this case, set the system so it conforms with the
input signal format.
■

Input signal display

Displays the frequency and the type of the current input
signal.
H-freq. 33.72
V-freq. 60.00
Dot clock freq. 74.18 MHz
Signal format 1125(1080)/60i
Display range:
Horizontal (15 kHz - 135 kHz)
Vertical (24 Hz - 120 Hz)
The dot clock frequency is displayed when Digital and
PC signal are input.
kHz
Hz