Colour System / Panasonic Auto; Cinema Reality; Xga Mode - Panasonic TH-42PF11EK Operating Instructions Manual

Colour system / Panasonic Auto

Select Signal from the "Setup" menu during AV(S Video) input signal. ("Signal [AV]"
menu is displayed.)
If the picture image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases
become unstable. Should this occur, set the system to match the format of the input signal.
Mode
Colour system
Panasonic Auto
(4 : 3)
Note:
Panasonic Auto does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.

Cinema reality

Cinema reality:
When on, the display attempts to reproduce a more natural interpretation of sources such as movie pictures, which
are recorded at 24 frames per second. If the picture is not stable, turn the setting to off.
Note:
When On, this setting only affects the following signal input:
• NTSC / PAL signal input during "AV(S Video)" input signal.
• 525i(480i), 625i(575i), 1125(1080) / 60i signal input during "Component" input signal.

XGA Mode

This menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA signals
with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz,
and 1,366 × 768 @ 60Hz). Be sure to make settings in accordance with the input signal in order to achieve a more
appropriate and attractive display.
In addition, after making this setting, be sure to make each adjustment (such as "Auto Setup") on the "Pos. /Size"
menu as necessary. (see page 22)
Press to select the "Colour system" or "Panasonic Auto".
Press to select each functions.
Set the colour system to match the input signal. When selecting "Auto", the colour system is automatically
selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
the attached terminal board. To display M.NTSC signal, select "M.NTSC" in Colour system.
Auto
Set to "4 : 3" to view 4:3 images in an unchanged format when Panasonic Auto is selected.
If you would like to view 4:3 images in Just format, set to "Just".
Press to select Cinema reality.
Press to set On / Off.
Press to select "XGA Mode".
Press to select "1024×768", "1280×768" , "1366×768".
Setup for Input Signals
Function
PAL SECAM M.NTSC
Signal
3D Y/C Filter (NTSC)
Auto
Colour system
Cinema reality
Panasonic Auto (4 : 3) 4 : 3
Noise reduction
NTSC
Cinema reality
XGA Mode 1024 × 768
[ AV ]
On
Off
Off
Off
39