Table of Contents
Advertisement
Using Network
Function
This unit has a network function and you can control the
Display connected to the network using your computer.
Necessary environment for
computers to be connected
First of all, confirm your computer whether it has a wired
LAN or a built-in wireless LAN.
Before connecting the Display to the computer, be sure
to check the following settings.
Check 1: About LAN cable
●
Is the cable connected properly?
●
To connect a device using 100BASE-TX, use LAN
cable that is compatible with category 5 or above.
Check 2: LAN settings
Computer with a built-in LAN function
●
Is your LAN switched on?
Computer without a built-in LAN function
●
Is your LAN adapter recognized properly?
●
Is your LAN adapter switched on?
●
Install the LAN adapter driver beforehand.
For details on how to install the driver, refer to the
instructions accompanying the LAN adapter.
■
About Web Browser
Web Browser is necessary to use WEB control.
●
Compatible OS:
Windows, Mac OS
●
Compatible Web Browser:
Internet Explorer 7.0 / 8.0 / 9.0 / 10.0 (Windows)
Safari 4.x / 5.x / 6.x (Mac OS)
72
English
Example of network connection
Note
●
To use the network function, set each item in
[Network settings] and make sure to set [Network
control] to [On].
(see page 58)
When it is set to [On], power indicator lights orange
under the condition of power "Off" with remote control
or <Power button (Unit)> (stand-by state).
■
LAN Terminal connection
Display (Back of the unit)
PC
LAN Terminal
LAN cable (commercially available)
Hub or broadband router
Note
●
For LAN cable, use shielded cable, otherwise picture
noise may be caused.
●
Make sure the broadband router or hub supports
10BASE-T/100BASE-TX.
●
Touching the LAN Terminal with a statically charged
hand (body) may cause damage to the device due to
its discharge.
Do not touch the LAN Terminal or the metal part of
the LAN cable.
●
For instructions on connection, consult your network
administrator.
Advertisement
Table of Contents
