Starting / Ending Media Player; Resume Play Function - Panasonic H-55LFV60U Operating Instructions Manual

Starting / ending Media Player

■
For Single Media Player
Start
1. Insert USB memory for Media Player.
Note
●
Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
2. Run a USB memory contents check.
3. Change INPUT to [USB].
Ending
Change INPUT to other than [USB].
■
For Multi Media Player
Start
1. Connect several units with LAN cables.
(See "Example of setting up LAN connection and IP
address / Subnet mask" in the previous section.)
2. Insert USB memory for Media Player into each
Display.
3. Executes USB memory contents check on each
Display.
4. Change INPUT for Slave to [USB].
5. Change INPUT for Master to [USB].
Ending
Change INPUT for Master to other than [USB].
90
English
USB terminal
USB memory

Resume Play function

After Media Player ends, the file to be resumed when
resuming playing varies depending on the setting of
[USB media player settings] - [Resume play].
When set to [On]:
The file played prior to the end of Media Player starts
playing from the beginning.
When set to [Off]:
Play starts from the beginning of the first file of the
scenario.
Note
●
The resume play function is retained until the unit is
turned off or the USB memory device is taken out.