Table of Contents
Advertisement
■
USB memory contents check
You can run a USB memory contents check in [USB
media player settings] - [Scenario file check].
(see page 60)
If an error is present, the information is given with the
following details.
A(B): C
A: Name of the file with an error
B: Row with an error
C: Error code
Note
●
Shows leading error codes.
Details of the detected errors are as follows.
Error
code
1.
No USB memory is inserted
2.
scenario.dat / filelist.dat cannot be opened
There is an error in writing scenario.dat /
3.
filelist.dat
4.
The play file format is not supported
5.
No play file exists
It is Multi Media Player, but no group ID is
6.
specified yet
7.
There are several identical file definitions
8.
The play time is outside the range
The file listed in the scenario is not in the
9.
file list
The scenario contains 0 or over 1000 play
10.
files
There are 0 or over 1000 play files (Single
11.
Media Player Type3 only)
Only the group ID is listed on the file list
12.
(Multi Media Player only)
Supplementary note
The USB memory contents check does not determine
whether or not a play file is playable.
If a file cannot be played while Media Player is active,
an error message will be displayed.
When performing the synchronized playback on the
Multi Media Player, check in the menu [USB media
player settings] - [Scenario file check] that the file is
playable.
Detail of the error
Network environment (Multi Media
Player only)
■
Example of setting up LAN connection and
IP address / Subnet mask
As mentioned below, connect several units together with
LAN cables and set up IP addresses / Subnet masks so
that all the displays exist on the same network.
Master
Slave
Slave
Slave
Note
●
Set [Network control] of all displays to [On]. (see page
58)
●
Depending on the network environment,
synchronization may be largely lost.
●
Do not connect other devices to prevent network
traffic jam.
●
With a router put in between, you cannot set up
connection. Use them within the same subnet.
●
Do not use wireless LAN for connection since
playback may not be performed normally.
IP address:
192.168.10.1
Subnet mask:
255.255.255.0
IP address:
192.168.10.2
Subnet mask:
255.255.255.0
IP address:
192.168.10.3
Subnet mask:
255.255.255.0
IP address:
192.168.10.4
Subnet mask:
255.255.255.0
English
89
Advertisement
Table of Contents
