Panasonic H-55LFV60U Operating Instructions Manual page 50

■
[Multi control auto setting]
In a serial daisy chain connection, this automatically
assigns ID numbers to subsequent-stage displays based
on the ID number of the first display.
Note
● If this setting is made on a display other than the
first one, display ID numbers may overlap among
the preceding-stage displays and subsequent-stage
displays. It is recommended to perform this setting on
the first display.
Select [Multi control auto setting] with
press <ENTER>.
Multi control auto setting
Status
Display ID
Network control / IP address
Start
Display ID
Changing network control
The following screen is displayed on the subsequent-
stage displays.
Multi control auto setting
Status
Display ID
Network control / IP address
[Status]
Displays the execution state of the display ID auto
setting.
[Wait]:
ID auto setting has not been executed yet.
[Finished]:
ID auto setting is completed.
[Display ID]
Displays the current display ID.
[Network control / IP address]
Displays [On] / [Off] of [Network control] function and
IP address.
50
English
Wait
0
Off
192.168.0.8
1
Yes
Wait
0
Off
192.168.0.8
Set each item.
Multi control auto setting
Status
Display ID
Network control / IP address
Start
Display ID
Changing network control
[Display ID]
Sets the ID you want to assign to the display you are
and
operating.
1 to 100
Note
● ID numbers are not automatically set for the
preceding-stage displays before the display on which
the operation is performed.
[Changing network control]
Sets whether to change settings in [Network control]
or maintain the current settings.
[No]:
Maintains the settings.
[Yes]:
Switches [Network control] to [On] when it is set to
[Off], and switches [DHCP] to [On].
Select [Start] and press <ENTER>.
Starts auto setting.
The following screen is displayed when the setting
is completed.
Multi control auto setting
Status
Display ID
Network control / IP address
●
When [DHCP] is set to [On], IP address is updated
automatically.
The following screen is displayed on the subsequent-
stage displays.
Multi control auto setting
Status
Display ID
Network control / IP address
● For each subsequent-stage display, an ID number
with 1 added to the ID number of each preceding-
stage display is assigned.
If the ID number of the preceding-stage display is
"100", ID number "1" is set.
● When [DHCP] is set to [On], IP address is updated
automatically.
Wait
0
Off
192.168.0.8
1
Yes
Finished
1
On
192.168.0.8
Finished
2
On
192.168.0.9