Table of Contents
Advertisement
Note
●
Up to 10 displays can be connected with a DVI daisy
chain. However, the number of connectable displays
may be limited depending on the cables, signals, the
devices used, etc.
●
HDCP can be supported for up to 8 displays for a DVI
daisy chain.
Pin assignments and signal names for DVI-D
Input/Output
Pin No.
T.M.D.S. data 2-
T.M.D.S. data 2+
T.M.D.S. data 2 shield
DDC clock
DDC data
T.M.D.S. data 1-
T.M.D.S. data 1+
T.M.D.S. data 1 shield
+5 V DC
GND (Ground)
Hot plug detect
T.M.D.S. data 0-
T.M.D.S. data 0+
T.M.D.S. data 0 shield
T.M.D.S. clock shield
T.M.D.S. clock+
T.M.D.S. clock-
Note
●
Use the supplied DVI-D cable. (Image deterioration
may occur depending on the length or the quality of
the cable.)
●
Securely tighten the screws at the both ends of the
DVI-D cable.
If the screws are not fixed securely, daisy chain
connection may be unstable.
20
English
Signal Name
PC IN terminal connection
(Female)
(Male)
Mini D-sub 15p cable (commercially available)
Conversion adapter (if necessary) (commercially
available)
Stereo mini plug (M3) cable (commercially available)
PC
The type of computer signal that can be connected
●
With regard to the typical PC input signals that
are described in "Preset Signals" (see page 93),
adjustment values such as for the standard picture
positions and sizes have already been stored in this
unit.
(Computer signals which can be input are those with
a horizontal scanning frequency of 30 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz.)
●
The display resolution is a maximum of 1 440 × 1 080
dots when the aspect mode is set to [4:3], and 1 920
× 1 080 dots when the aspect mode is set to [16:9].
If the display resolution exceeds these maximums, it
may not be possible to show fine detail with sufficient
clarity.
●
In [ENGLISH(US)] OSD language, [16:9] is displayed
as [FULL].
Shared with DVI-D IN.
Stereo mini plug
(M3)
Connect a cable
which matches
the audio output
terminal on the
computer.
(commercially
available)
Advertisement
Table of Contents
