Display Removal (With Display Removal Fixture); Lens Removal Fixture Setup - Motorola Moto E Service & Repair Manual

If the Display Lens is damaged, continue to
Display Removal (Damaged Display Lens Only)
on page 30. Do not use the Display Removal
(With Display Removal Fixture) procedure if the
Display Lens is damaged.
1. Verify that the Vacuum O-ring is positioned in the
Generic Lens Removal Fixture (4-00-X2-
10000/4-00-X7-10000) as shown.
The Generic Lens Removal Fixture vacuum will
not perform correctly if the Vacuum O-ring is not in
position.
2. Place the Styx Lens Removal Fixture (4-00-X6-
10000) into the Generic Lens Removal Fixture.
3. Press the black power switch (not shown) on the
back of the Generic Lens Removal Fixture to turn
the fixture ON.
4. Turn the vacuum knob (circled) clockwise until it
stops.
5. Wait 5-10 minutes for the Generic Lens Removal
Fixture to warm up to 100 °C (212°F).
Damage to the assembly may occur if the Generic
Lens Removal Fixture is not warmed up to
operating temperature before use.
If the controller on the Generic Lens Removal
Fixture must be adjusted, see the user manual on
page 126.
Pre-Heat Method A and Pre-Heat Method B are
optional procedures that may be used to reduce
the Display Removal process time.