Motorola Moto E Service & Repair Manual page 119

Verify that the ISP Alcohol and 3M AP-111 applied
to the Display have dried completely before
proceeding. Failure to do so can cause the
Display to improperly adhere.
9. Insert the Display Flex into the Display Flex ZIF
Connector. Use the white line on the Display
Flex as a guide for insertion depth.
If the phone is accidentally powered on, shut it
down by holding the Power Key and tapping
"Power Off" on the Display.
Do not damage or tear the Display Flex.
10. Slide a fingertip across the Display Flex ZIF
Connector Door to close it.
11. Place Kapton Tape over the Display Flex ZIF
Connector.
12. Connect the Battery Connector to the PCB.