Yamaha QL5 Reference Manual page 31

STEP
1. Set the phantom power, gain, and phase of the input channel from which you want
to send the signal to the STEREO/MONO bus.
2. Press the Bank Select keys in the Fader Bank section and the [SEL] keys on the top
panel to select the input channel from which you want to send the signal to the
STEREO/MONO bus.
3. In the PAN/BALANCE field, press a knob to select the channel you want to adjust in
the SELECTED CHANNEL VIEW screen, and then press the knob once again.
4. Use the MODE select button in the TO STEREO/MONO window to select either ST/
MONO mode or LCR mode for each channel.
5. In the MASTER section on the top panel, turn on the [ON] key for the ST IN channel
(stereo)/INPUT channel (monaural), and then raise the fader to an appropriate
level.
6. In the INPUT section on the top panel, turn on the [ON] key for the input channel
you want to control, and then raise the fader to an appropriate position.
The subsequent steps will differ depending on whether ST/MONO mode or LCR mode was
selected for the channel in step 4.
Channels for which ST/MONO mode is selected
7. In the TO STEREO/MONO window, use the STEREO/MONO button to individually
turn on/off the signal sent from the input channel to the STEREO bus/MONO bus.
8. Use the TO ST PAN knob to set the panning of a signal sent from the input channel
to the STEREO bus.
Channels for which LCR mode is selected
7. In the TO STEREO/MONO window, use the LCR button to turn signals sent from the
input channel to the STEREO bus/MONO bus on or off collectively.
8. Use the CSR knob to adjust the level difference between signals sent from that
channel to the STEREO (L/R) bus and to the MONO (C) bus.
9. Use the TO ST PAN knob to specify the panning of signals sent from the input
channel to the STEREO (L/R) bus and MONO (C) bus.
SELECTED CHANNEL VIEW screen TO STEREO/MONO window
TO STEREO/MONO window (8ch)
Here you can control the on/off and pan/balance settings of signals sent from input channels
to the STEREO (L/R) bus and MONO (C) bus, in groups of eight channels.
1
2
3
4
5
6
7
ST/MONO mode
1
Channel select button
Selects the channel. You can select multiple channels simultaneously.
2
Mode LEDs
The LED of the currently-selected mode will light.
3
MODE select button
For an INPUT channel (monaural), the mode can be switched between ST/MONO and
LCR. For a STEREO channel, the mode can be switched between PAN and BALANCE.
4
ST/MONO buttons
These buttons are on/off switches for signals that are sent from each channel to the
STEREO bus/MONO bus when the MONO button is set to ST/MONO mode.
5 Σ clipping indicator
Lights to indicate a signal is clipping at some point in the channel.
31
Input channels
LCR mode
Reference Manual