Inserting An Internal Effect Into A Channel; Editing The Internal Effect Parameters - Yamaha QL5 Reference Manual

Inserting an internal effect into a channel

This section explains how to insert an effect into a channel by assigning the input/output of
the internal effect to the input/output of the desired channel (except for a ST IN channel). For
details on editing the effect parameters, refer to
page 134.
STEP
1. Follow steps 1–3 described in "Virtual rack
effect in a rack.
2. Press the INPUT PATCH L button in the VIRTUAL RACK window, and select the insert-
out for one of the channels as the input source for the rack
3. Press the OUTPUT PATCH L button in the VIRTUAL RACK window, and select the
insert-1in or insert-2in of the same channel as the output destination for the rack
(page 119).
4. Use the Bank Select keys and the [SEL] key to select the channel into which you
inserted the effect.
5. Press the popup button in the INSERT field in the SELECTED CHANNEL VIEW screen.
6. In the INSERT/DIRECT OUT popup window, turn on the INSERT ON/OFF button for
the channel into which you inserted the effect.
7. Display the EFFECT EDIT window again, and select the effect type and edit the effect
parameters.
8. Using the fader of the channel you selected as the rack's output destination in step
3, adjust the level as appropriate.
NOTE
• If you are inserting an effect into a channel that handles a stereo source, assign the R channel
insert-out/insert-in to the R input and output of the effect in the same way as step 3.
• For more information about how to operate the INSERT/DIRECT OUT window, refer to
an external device into a channel" on
• The levels before and after the effect are shown by the input and output meters in the upper right
of the EFFECT EDIT window.
• Adjust the effect send master level and the effect parameters so that the signal does not reach
the overload point at the input or output stage of the effect.
"Editing the internal effect parameters" on
operations" on page 119, to mount an
(page 119).
page 18.

Editing the internal effect parameters

This section explains how to change the effect type and edit the parameters. For a rack in
which an effect is mounted, the following information is shown in the VIRTUAL RACK window.
1
1
Effect title/type
Displays the effect title, the name of the type that is used, and a graphic. The number
of input and output channels (1 IN/2 OUT or 2 IN/2 OUT) of this effect is also shown.
2
Input/output meters
Indicate the level of the signals before and after the effect.
STEP
1. Press the rack container in which the effect you want to edit is mounted.
2. To change the effect type, press the effect type field in the EFFECT EDIT window, and
select the effect type in the EFFECT TYPE window.
3. Press a knob in the effect parameter field in the EFFECT EDIT window to select it,
and turn the [TOUCH AND TURN] knob to edit the effect parameters.
4. Edit the settings in the special parameter field as necessary.
"Inserting
134
Graphic EQ, Parametric EQ, effects, and Premium Rack
2
Reference Manual