Install The Converter; Limitation; Stand-Alone Installation - Planet VF-101-T User Manual

This section describes how to install your VF-10x Media Converter and make connections to the converter. Please read
the following topics and perform the procedures in the order being presented. The hardware installation of PLANET
VF-10x Media Converter do not need software configuration. To install your VF-10x on a desktop or shelf, simply complete
the following steps.

3.1 Limitation

The converter does not require any software configuration. Users can immediately use any feature of this product simply
by attached the cables and plug power on. There is some key limitation on the video over fiber converter. Please check
the following items:
The device is used for Point-to-Point connection only (transmitter to receiver) and allows video and data work on
the same optical fiber patch cord.
The BNC connector and supports 75 ohm cable. The distance will change by the quality of coaxial cables.

3.2 Stand-alone Installation

To install a VF-10x-T / VF-10x-R stand-alone, on a desktop or shelf, simply complete the following steps:
Step 1: Turn off the power of the analog camera / monitor to which the VF-10x-T / VF-10x-R will be attached.
Step 2: VF-10x-T (Transmitter): Connect coaxial cable from analog camera to Video BNC port of the VF-10x-T.
Step 3: Attach FC single mode fiber cable from the VF-10x-T to VF-10x-R in the remote side.
Step 4: VF-10x-R (Receiver): Connect coaxial cable from monitor / DVR to Video BNC port of the VF-10x-R.
Step 5: Connect the 5V DC power adapter to the VF-10x-T / VF-10x-R and verify that the Power LED lights up.
Step 6: Turn on the power of the analog camera / monitor; the VIDEO LED (Green) should light when all cables are
attached.

3 INSTALL THE CONVERTER

11