Advertisement

Eldningsinstruktion
SE
Heizinstruktionen
DE
Fyringsinstruksjon
NO
Instructions d'allumage
FR
Fyringsvejledning
DK
Lämmitysohjeet
FI
Istruzioni per l'accensione
IT
Stookinstructies
NL
Lighting Instructions
GB
contura.eu
2
9
16
23
30
37
44
51
58
Lighting
Instructions
C600 Style

Advertisement

Table of Contents
loading

Summary of Contents for Contura C600 Style Series

  • Page 1 Lighting Eldningsinstruktion Heizinstruktionen Fyringsinstruksjon Instructions Instructions d’allumage Fyringsvejledning Lämmitysohjeet Istruzioni per l’accensione Stookinstructies Lighting Instructions C600 Style contura.eu...
  • Page 2 Lighting Instructions Lighting in the right way Your Contura fireplace is designed to provide secondary heating in your home. It is important that the correct amount of wood is used, especially when lighting. If you are lighting the fire for the first time, you should use a set of scales to see how much 2.0 kg kindling is.
  • Page 3: Lighting The Fire

    Lighting Instructions lighting the fi re NOTE: The left handle that controls the grate disc and booster must be Note that if too little kindling is used when lighting, or if the wood is too closed when lighting the fire. thickly cut, the firebox will not reach the correct operating temperature.
  • Page 4 Lighting Instructions Adding logs Feeding wood: 1. Open the door a few centimetres and allow the vacuum in the firebox to Chopped wood equalise for a few seconds before opening the door fully. Length: 25-36 cm Diameter: 7-9 cm 2. Add 2 logs weighing about 1.5-2.5 kg together. Place one log diagonally Normal amount: 1.8 kg/hour (2 logs) across the other as illustrated.
  • Page 5: Lighting For The First Time

    Lighting Instructions Choosing fuel The wood’s moisture content All types of wood, such as birch, beech, oak, elm, ash, conifers and fruit Fresh wood is about 50 per cent water. The wood must always be dried so trees can be used as fuel in the fireplace. Different types of trees have that the moisture content is below 20%.
  • Page 6 Painted parts of the stove can be cleaned using a damp cloth and, if necessary, some washing-up liquid. Scratches on painted surfaces can be repaired using Contura touch-up paint. Contact your dealer. The constant flow of air through the stove, as cold air is drawn in from the room and hot air is released, can cause dust to collect behind and under the stove.
  • Page 7: Fuel Overloading

    UK Smoke control areas The Contura 600 Style series, 6 kW woodburning stoves listed below have been recommended as suitable for use in smoke control areas when burning wood logs and operated in accordance with these instructions and when fitted with a permanent stop to prevent closure of the air control vent beyond the 25 mm open position when sold into smoke control areas.
  • Page 8 Lighting Instructions hEAlTh AND SAFETY PrECAUTIONS STOVE PErFOrMANCE Special care must be taken when installing the stove such that the require- Refer to the manufacturer’s main instruction manual for details of the ments of the Health and Safety at Work Act are met. stove’s performance.
  • Page 9: Combustion Air Supply

    Lighting Instructions Chimney Any bend in the chimney or connecting fluepipe should not exceed 45°. 90° bends should not be used. Combustible material should not be located In order for the stove to perform satisfactorily the chimney height must where the heat dissipating through the walls of fireplaces or flues could be sufficient to ensure an adequate draught of approximately 15 Pa so as ignite it.
  • Page 10: Chimney Cleaning

    Lighting Instructions hETAS ltd Approval; IMPOrTANT NOTES These appliances have been approved by HETAS Ltd as an intermittent General operating appliance for burning wood logs only. Before lighting the stove check with the installer that the installation work WArNING NOTE and commissioning checks described above have been carried out correctly and that the chimney has been swept clean, is sound and free from any ob- Properly installed, operated and maintained this stove will not emit fumes...
  • Page 11: Aerosol Sprays

    Lighting Instructions Aerosol sprays USEr OPErATING INSTrUCTIONS Do not use an aerosol spray on or near the stove when it is alight. Please read the important notices given above before referring to the main Use of operating tools instruction book for detailed operating instructions. Always use the operating tools provided when handling parts likely to be hot recommended fuels: when the stove is in use.
  • Page 12 The warranty does not cover damage of this type. If a problem occurs that you cannot rectify yourself, contact the dealer or a chimney sweep. We hope that these lighting tips give you enjoyable, economical and problem free use of your Contura fireplace.
  • Page 13 Lighting Instructions Installation Instructions for Damper Blocker, mandatory for Smoke Control Areas The damper block is magnetic but must also be clamped between the two steel bars as indicated in the diagram below. Damper Blocker for C500 and C600 Style series.
  • Page 14: Waste Management

    In serious cases, ash can find its way out through the damper. NIBE AB Box 134 SE-285 23 Markaryd Sweden www.contura.eu Contura reserves the right to change dimensions and procedures specified in these instructions at 811312 BAV SE-EX C600-3 any time without notice. The current edition can 2018-03-07 be downloaded from www.contura.eu...
  • Page 16 NIBE AB Box 134 SE-285 23 Markaryd Sweden www.contura.eu Contura reserves the right to change dimensions and procedures described in these instructions 811312 BAV SE-EX C600-3 at any time without special notice. The current 2018-03-07 edition can be downloaded from www.contura.eu...

Table of Contents