• If the VTR SAVE/STBY switch is in the STBY
position, recording starts immediately.
However, just after the switch position is
changed from SAVE to STBY, it takes about 4
seconds before recording starts.
If you turn off the power during a
recording pause mode
2
3
1
1
Turn on the power again.
2
Press the RET button on the lens.
If an analog composite signal is input to the
GEN LOCK IN connector, make sure that
RETURN VIDEO (see page 86) is set to OFF
on the ASSIGNABLE SW page of the
OPERATION menu.
The camcorder positions the tape at the
appropriate point. Note, however, that this
function works only for continuously
recorded material or consecutively joined
segments totaling at least 3 seconds in length.
3
Press the REC START button on the
camcorder or the VTR button on the
lens to start recording.
Continuous recording in other cases
After rewinding or fast forwarding, after
removing the cassette, or on a tape that has been
partially recorded, you can obtain a continuous
recording by following the procedure below.
The End Search function also allows you to
continue recording on a partially recorded tape.