Table of Contents
Advertisement
7
Chapter
Testing the Camcorder
Before Shooting
Check the functions of the camcorder before
setting out for a shooting session, preferably by
operating the camcorder together with a color
video monitor.
Preparations for Testing
1
Attach a fully charged battery pack.
2
Set the POWER switch to ON and
check that the HUMID indicator does
not appear and that the BATT indicator
shows at least five segments.
• If the HUMID indicator appears, wait until
it disappears.
• If the BATT indicator does not show at
least five segments, replace the battery
pack with a fully charged one.
3
Check that there are no obstructions
near the cassette compartment, and
then press the EJECT button to open
the cassette compartment lid.
146
Testing the Camcorder Before Shooting
Maintenance
3
4 1
2
4
After confirming that the cassette tape
is not write-protected, load the cassette
tape and close the cassette compartment
lid.
Testing the Camera
Set the switches and selectors as follows.
1
2
1 Iris switch: Automatic
2 Zoom selector: SERVO/MAN
3 VTR SAVE/STBY switch: SAVE
4 GAIN selector: Set as low as possible.
5 OUTPUT/DCC switch: BARS
6 WHITE BAL switch: A or B
Testing the viewfinder
1
Adjust the position of the viewfinder.
2
Check that the color bars are displayed
on the viewfinder screen, and adjust the
BRIGHT, CONTRAST, and
PEAKING controls to give the best
color bar display.
3
4
5 6
Advertisement
Table of Contents
