Yamaha XT660R 2004 Service Manual page 353

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Fault
code No.
An error is detected while reading or
44
writing on EEPROM.
Power supply to the fuel injection sys-
tem relay is not normal.
46
Faulty ECU memory. When this mal-
50 function is detected, the code number
might not appear on the meter.
No signals are received from the
ECU.
Er-1
No signals are received from the ECU
within the specified duration.
Er-2
Data from the ECU cannot be
received correctly.
Er-3
Non-registered data has been
received from the meter.
Er-4
EAS00907
Diagnostic mode table
Switch the meter display from the regular mode to the diagnostic mode. To switch the display, refer
to "DIAGNOSTIC MODE".
NOTE:
_
• Check the intake air temperature and coolant temperature as close as possible to the intake air
temperature sensor and the coolant temperature sensor respectively.
• If it is not possible to check the intake air temperature, use the ambient temperature as reference.
Diagnostic
Item
code
Throttle angle
01
Intake air pressure
03
Intake air temperature
05
Coolant temperature
06
Vehicle speed pulse
07
email: info@motomatrix.co.uk
FUEL INJECTION SYSTEM
Symptom
• Malfunction in ECU (The CO adjustment value is not
properly written on or read from the internal memory.)
• Open circuit in wire harness
• Malfunction in rectifier/regulator
• Malfunction in A.C. magneto rotor
Refer to "CHARGING SYSTEM" in chapter 8.
• Malfunction in ECU (The program and data are not prop-
erly written on or read from the internal memory.)
• Open or short circuit in sub-wire harness
• Disconnected ECU coupler
• Malfunction in meter
• Malfunction in ECU
• Improper connection in sub-wire harness
• Disconnected ECU coupler
• Malfunction in meter
• Malfunction in ECU
• Improper connection in sub-wire harness
• Disconnected ECU coupler
• Malfunction in meter
• Malfunction in ECU
• Improper connection in sub-wire harness
• Disconnected ECU coupler
• Malfunction in meter
• Malfunction in ECU
Displays the throttle angle.
• Check with throttle fully closed.
• Check with throttle fully open.
Displays the intake air pressure.
Set the engine stop switch to "
• Generate the pressure difference by cranking the
engine with the start switch, but do not start the
engine.
Displays the intake air temperature.
• Check the temperature in the air filter case.
Displays the coolant temperature.
• Check the coolant temperature.
Displays the accumulation of the vehicle speed
pulses that are generated when the tire is spun.
Probable cause of malfunction
Action
".
7 - 10
FI
Diagnostic code
60
09
—
—
—
—
—
Data displayed on meter
(reference value)
0 ~ 125 degrees
• Fully closed (15 ~ 17 degrees)
• Fully open (97 ~ 100 degrees)
When the engine is stopped:
Atmospheric pressure 101.3 kPa
(760 mmHg, 30 inHg)
When cranking the engine with start
switch:
1.3 ~ 26.6 kPa
(10 ~ 200 mmHg, 0.4 ~ 7.9 inHg)
Compare the temperature in the air
filter case to the value displayed on
the meter.
Compare the coolant temperature to
the value displayed on the meter.
(0 ~ 199; resets to 0 after 199)
OK if the numbers appear on the
meter.