Switching Off The Washer; Disconnecting Supply Lines; Storing The Washer (Below 0°C) - Nilfisk-ALTO POSEIDON 2-26 PORTABLE Operating Instructions Manual

5 After using the washer
5.1 Switching off the
washer
5.2 Disconnecting supply
lines
5.3 Storing the washer
(below 0°C)
1. Store the washer in a dry
room without danger of frost
or protect as below:
CAUTION!
If the high-pressure washer is
stored in a room with tempera-
tures around or below 0°C, anti-
freeze should be drawn into the
pump beforehand:
1. Remove the water inlet
hose from the washer.
2. Remove the spray lance.
3. Connect the suction hose to
the water inlet of the washer
and place it in a tank con-
taining anti-freeze.
4. Switch on the washer with
the main switch in position
»I«.
1. Turn the main switch to posi-
tion »0«.
2. Close water tap.
3. Activate the spray handle
until the washer is depres-
surised.
4. Lock the safety catch on the
spray handle.
1. Remove the water hose
from the washer.
2. Pull out the plug from the
electrical socket.
5. Hold the spray handle over
the tank containing anti-
freeze and operate it to start
suction.
6. During suction operate the
spray handle two or three
times.
7. Lift the suction hose from
the tank containing anti-
freeze and operate the
spray handle to pump off
the remaining antifreeze.

8. Switching off the washer

9. Disconnect the plug from
the socket.
10. To avoid any risks, store
the washer temporarily in a
heated room before using it
again.
EN
39