Setting Up The Washer; Connecting The High Pressure Hose; Connecting The Water Supply - Nilfisk-ALTO POSEIDON 2-26 PORTABLE Operating Instructions Manual

3 Before starting the washer
3.1

Setting up the washer

3.2 Connecting the high
pressure hose
3.3 Connecting the water
supply
Max.
Min.
Do not connect the washer
directly to the public drinking
water mains. Observe the
regulations of your water supply
company to prevent backfl ow of
water into the supply line.
A connection is permitted,
however:
1. Before using the washer for
the fi rst time, check it care-
fully to detect any faults or
damage.
2. In the event of any damage
contact your dealer
immediately.
3. Check whether the oil level
is between the minimum and
maximum marks. If neces-
sary, add oil (see chapter
8.3 for type of oil). NOTE:
Set the machine in upright
position when checking the
pump oil.
1. Screw the quick connec-
tor of the high pressure
hose onto the nipple on the
washer (7).
– briefl y to a pipe interrupter
with moving section
– with a free outlet
See chapter 8.3 Technical Data
for required quantity of water
and water pressure.
In the case of poor water quality
(sand, etc.), we recommend that
a fi ne water fi lter is fi tted in the
water inlet.
1. Rinse the water supply hose
briefl y in order to prevent
sand an other dirt particles
entering into the machine.
2. Connect water supply hose
to the machine (3/4").
3. Open water tap.
EN
37