Before You Begin; Parts List; Tools Needed - AT&T 945 User Manual

BEFORE YOU BEGIN

Parts List

Your box should include:
USER'S MANUAL
Four-Line Intercom
Speakerphone 945
Part 1 — Important
Product Information
© 2004 Advanced American Telephones. All Rights Reserved.
AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American Telephones.
Two seven-foot line cords
Base Unit

Tools Needed

You will also need a small Phillips head screw driver to install your phone.
2
This User's
Manual
Part 2
Please also read
Eight-inch line cord
QUICK START GUIDE
Four-Line Intercom
Speakerphone 945
This Quick Start Guide provides basic instructions. Table/Desk Installation
For addtional installation options and complete
For best results, follow the directions in "Battery Installation"
instructions which allow you to use all features above, before installing the phone.
of this phone, refer to your User's Manual.
1 Connect the telephone line cords to the
telephone as shown in the appropriate
INSTALLATION illustration below.
• Four One-Line Jacks (To use this installation
Installation of a DSL splitter and an AT&T Z800A filter
option, you'll need to purchase two two-line
is required to use the advanced features of this
adapters. Adapters are available at retail stores or
telephone if you have DSL (Digital Subscriber Line) 1 800 222–3111
by calling .)
service. Please see "DSL Users" starting on page 4 of
your User's Manual for details.
Modular
If you are installing multiple phones in your phone
telephone jacks
Lines 3 and 4
system, you must install and program one set at a time.
Each phone must be assigned a unique extension
Two-line adapters
number.
Telephone line cords
Battery Installation
Install a 9V alkaline battery (purchased separately) in order to
use some features of this telephone in the event of a power
failure.
1 Remove the wedge from the underside of the
L3/L4 jack L1/L2 jack
base unit. Press on the tabs and pull the wedge away
from the phone.
2 Remove the battery compartment screw with • Two Two-Line Jacks
a small Phillips head screwdriver.
3 Pull on the tab to remove the battery
Modular Modular telephone
compartment cover. telephone jack jack Lines 1 and 2
Lines 3 and 4
4 Insert a 9V battery (purchased separately)
Telephone
following the polarity diagram inside the battery
line cords
compartment.
5 Replace the battery compartment cover and
the screw.
6 Reattach the wedge to the base unit by sliding the
tabs into the holes. Snap the wedge onto the base.
L3/L4 jack L1/L2 jack
2 Connect the handset cord.
Plug one end of the coiled handset cord into the jack
on the left side of the phone. Plug the other end into
the handset and hang up.
Power adapter
Modular
telephone jacks
Lines 1 and 2
Handset
Coiled
handset cord