Toyota 2008 Tundra Owner's Manual page 67

07 11.20
The system can memorize up to 2 posi-
tions by repeating the above steps. If step
2 is performed for a button that already
has a memory setting, the previous posi-
tion will be erased and the new position
will be memorized.
To make only slight changes to an already
memorized position, the easiest way is to
first activate the memorized position, then
make the desired changes and perform
step 2 above.
XS13099a
RECALLING THE MEMORIZED POSITION
When you push button "1" or "2", a
beep will sound and the driving posi-
tion will be automatically adjusted to
the position recorded for that button.
The memorized position can be recalled
under the following conditions:
The engine switch is in the "ON" posi-
D
tion and the selector lever is in the "P"
position.
The key is not in the engine switch
D
and less than 30 seconds have passed
since opening the driver's door.
To stop the operation, push any driving
position memory button.
To reactivate the system, push button "1"
or "2" again.
If the vehicle's battery is disconnected,
the memory will be erased and the posi-
tions will have to be set again.
CAUTION
Do not start the vehicle while the
D
adjustment are being made.
Take care not to select the wrong
D
button, or the seat could strike the
rear passenger or hit your body
against the steering wheel. If this
happens, you can stop the move-
ment by pressing another driving
position memory switch,
pressing the brake pedal.
2008 TUNDRA from Apr. '08 Prod. (OM34477U)
or de-
57