Toyota 2008 Tundra Owner's Manual page 134

07 11.20
Same angle
Same position
XS13151
Bench seat: In order to firmly se-
D
cure the child restraint system to
the center front passenger seat,
align the seatback angle and seat
position of the right front passen-
ger seat to match the center front
passenger seat. If the child restraint
system cannot be firmly secured,
install it onto the right front pas-
senger seat. Otherwise, it
cause death or injury in a collision.
Bench seat: If the child restraint
D
system installed on the center front
passenger seat interferes with the
driver, install it onto the right front
passenger seat.
124
XS13047
To install the forward−facing convertible
seat:
1. Run the lap and shoulder belt through
or around the convertible seat following
the instructions provided
manufacturer and insert the tab into
the buckle taking care not to twist the
belt. Keep the lap portion of the belt
tight.
For instructions concerning the installation
could
of the rear−facing convertible seat, see
"(A) INFANT SEAT INSTALLATION" on
page 118.
CAUTION
After inserting the tab, make sure
D
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
Do not insert coins, clips, etc. in
D
the buckle as this may prevent your
child from properly latching the tab
and buckle.
If the seat belt does not function
D
normally, it cannot
child from death or serious injury.
Contact your Toyota dealer immedi-
ately. Do not install
restraint system on the seat until
the seat belt is fixed.
by its
2008 TUNDRA from Apr. '08 Prod. (OM34477U)
protect your
the child