Toyota 2008 Tundra Owner's Manual page 525

07 11.20
Torque specification:
Taper type (Steel wheels)—
209 N·m (21.3 kgf·m, 154 ft·lbf)
Flat washer type
(Aluminum wheels)—
131 N·m (13.4 kgf·m, 97 ft·lbf)
∗
: When temporarily used on spare
tire/wheel, apply 209 N·m (21.3
kgf·m, 154 ft·lbf)
—After changing wheels
10.Check the air pressure of the re-
placed tire.
Adjust the air pressure to the specifi-
cation designated on page 594 in
Section 8. If the pressure is lower,
drive slowly to the nearest service
∗
station and fill to the correct pressure.
Do not forget to reinstall the tire infla-
tion valve cap as dirt and moisture
could get into the valve core and
possibly cause air leakage. If the cap
is missing, have a new one put on as
soon as possible.
11. Restow all the tools, jack and
flat tire securely.
As soon after changing wheels as
possible, tighten the wheel nuts to the
torque specified on page 515 with a
torque wrench. Have a technician re-
pair the flat tire and replace the tem-
porary spare tire with it.
Initial adjustment of
pressure warning system
necessary after your have replaced
your tires or wheels. See "Tire
pressure warning system" on page
254 in Section 1−7.
CAUTION
Before driving, make sure all the
tools, jack and flat tire are se-
curely in place in their storage
location to reduce the possibility
of personal injury during a colli-
sion or sudden braking.
2008 TUNDRA from Apr. '08 Prod. (OM34477U)
the tire
is
515