Toyota 2008 Tundra Owner's Manual page 61

07 11.20
1. SEAT POSITION ADJUSTING LEVER
Hold the center of the lever and pull
it up. Then slide the seat to the de-
sired position with slight body pres-
sure and release the lever.
2. SEATBACK ANGLE ADJUSTING
LEVER
Lean forward and pull the lever up.
Then lean back to the desired angle
and release the lever.
3. DRIVER'S SEAT CUSHION
ADJUSTING KNOB
To change the angle of the seat
cushion on the front side, turn the
knob either way.
4. DRIVER'S SEAT HEIGHT ADJUSTING
LEVER
To change the height of the seat,
pull up or push down the lever.
5. DRIVER'S SEAT LUMBAR SUPPORT
ADJUSTING SWITCH
Push the switch on either side.
The amount of lumbar support will
change while the switch is pushed.
CAUTION
Avoid reclining the
more than needed. The seat belts pro-
vide maximum protection in a frontal
or rear collision when the driver and
the front passenger are sitting up
straight and well back in the seats. If
you are reclined, the lap belt may
slide past your hips and apply re-
straint forces directly to the abdomen
ANGLE
or your neck may contact the shoul-
der belt. In the event of a frontal
collision, the more the seat is re-
clined, the greater the risk of death
or serious injury.
seatback any
XS13145b
Bench seats (Regular cab models)
2008 TUNDRA from Apr. '08 Prod. (OM34477U)
51