Replacing Light Bulbs - Toyota 2006 Tundra Owner's Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not
D
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
D
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
470
'06 TUNDRA_U (L/O 0508)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
if
Light bulbs
Headlights
Front fog lights
Parking lights
like the
Front turn
signal/front side
marker lights
contact your
Rear turn signal
lights
Stop/tail/rear
side marker
lights
Back−up lights
License plate
lights
High mounted
stoplight and
cargo lamps
Interior light
Front personal
lights
Type A and C
Type B
Center personal
lights
2006 TUNDRA from Oct. '06 Prod. (OM34458U)
Bulb
W Type
No.
— 60/55 A
9006 51 B
168 5 D
3157A 27/8 C
— 21 C
— 21/5 D
921 18 D
168 5 D
921
18 D
— 8 E
— 10 E
— 3.8 D
— 3.8 D