Detection Of Cookware; Residual Heat Indicator; Booster Function - Philco PHD 64F4S User Manual

NOTE:
You can set the timers in the same way as the hotplate power level settings.
If you do not press any button for 20 seconds, the hotplates will return to the stand-by mode.

Detection of cookware

The detection of cookware function ensures the safe operation of the cooktop. The induction cooktop will not
function if:
-
there is no cookware on the hotplate or if the cookware is not suitable for use on an induction cooktop.
In such a case, it will not be possible to set a power level and the display will show "U". The symbol will
disappear when you place the correct type of cookware on the hotplate.
-
Remove the cookware from the hotplate, operation will be ended. The display will show "U". This symbol
will disappear when you place the cookware back on to the hotplate. The cooking process will continue
at the set power level.
After fi nishing cooking, turn off the hotplate. Do not allow the detection of cookware function to be activated
unnecessarily.

Residual heat indicator

The appliance is equipped with a residual heat function. If the temperature of the hotplate is higher than 50 °C
after it is turned off , the letter "H" will appear on the display, indicating the danger of a hot hotplate. Wait until
the indicator (letter H) turns off . Otherwise there exists a risk of burns or a fi r e.

Booster function

The appliance is equipped with a Booster function [P] and a double Booster function
This function shortens the cooking time by setting the maximum power level for 10 minutes. This function
is suitable for speeding up the heating of large amounts of liquids or sauces.
To set the Booster function, press the Booster button, the P symbol will start fl ashing on the display, then slide
your fi nger along the power selection zone until the P symbol stops fl ashing.
To turn off the Booster function, slide your fi nger along the power selection zone until 0 appears on the display.
To set the double Booster function, press the Booster button twice, the P symbol will start fl ashing on
the display, then slide your fi nger along the power selection zone until the symbol
display.
To turn off the double Booster function, slide your fi nger along the power selection zone until 0 appears on
the display.
NOTE:
The cooktop is equipped with the maximum power output. If the booster function is activated
and does not surpass the maximum power level, the electronic system will automatically set the power
of another hotplate to a lower level. "9" will start fl ashing on the display within a few seconds and then
the maximum permitted power level from "6" to "8" will appear.
Copyright © 2014, Fast ČR, a. s.
.
and P appear on the
EN - 7
04/2014