Memory; Keep Warm Function; Bridge Function - Philco PHD 64F4S User Manual

Memory

After turning off the cooktop using the 0/I button, it is possible to renew the last setting, i.e.:
-
settings of all hotplates (Booster);
-
minutes and seconds of timers on selected hotplates;
- automatic cooking;
-

keep warm function;

To renew the last settings, turn on the cooktop using the 0/I button and then press the STOP button before the
indicator light stops fl ashing. The last settings will be renewed.
Keep warm function
This function enables the cooktop to reach and automatically maintain a temperature of approximately 42 °C,
70 °C or 94 °C.
In this way it prevents pots from boiling over as well as the burning of food.
To activate the function of maintaining a temperature of 42 °C, slide your fi nger along the temperature
selection zone between 0 and 1, until the
To activate the function of maintaining a temperature of 70 °C, press the keep warm button once and then
slide your fi nger along the temperature selection zone until the
To activate the function of maintaining a temperature of 94 °C, press the keep warm button twice and then
slide your fi nger along the temperature selection zone until the
To cancel the function, slide your fi nger along the temperature selection zone until 9 appears on the display.
The maximum time that can be set for the keep warm function is 2 hours.

Bridge function

This function makes it possible to use two hotplates on the left at the same time like a single hotplate.
2 hotplates
Turn on the cooktop using button 0/I. "0" will appear on the display. To activate the bridge, simultaneous press
the power selection zones of two hotplates.
fi nger along the power selection zone, which indicates the power level, and the set power level will appear
on the display.
To cancel the function, simultaneous press the power selection zones of the two selected hotplates. "0" will
appear on the display.
4 hotplates
Turn on the cooktop using button 0/I. "0" will appear on the display. To activate the bridge, simultaneous press
the power selection zones of the two rear hotplates.
slide your fi nger along the power selection zone, which indicates the power level, and the set power level will
appear on the display.
To cancel the function, simultaneous press the power selection zones of the two selected hotplates. "0" will
appear on the display.
Copyright © 2014, Fast ČR, a. s.
symbol appears on the display.
symbol appears on the display.
symbol appears on the display.
will appear on the display. To set the power level, slide your
will appear 3x on the display. To set the power level,
EN - 9
04/2014