Table of Contents
Advertisement
The oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under the
guarantee) from most electrical stores. Ask for an Edison
screw fitting 15 W 230 V lamp, FOR OVENS (Fig.6-1). It
must be a special bulb, heat resistant to 300 °C.
Before removing the existing bulb, turn off the power
supply and make sure that the oven is cool. Open the
oven door and remove the oven shelves.
Locate the bulb cover and unscrew it by turning it
counter-clockwise – it may be very stiff (Fig.6-2).
Taking care to protect your fingers with a glove in case
the bulb should shatter, unscrew the old bulb.
Screw in the new bulb clockwise and then screw the
bulb cover back on. Turn on the electricity supply and
check that the bulb now lights.
The oven door is misaligned
The bottom hinge of the left hand oven door can be
adjusted to alter its angle (Fig.6-3). Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig.6-4).
Retighten the hinge screws.
ArtNo.320-0006 Oven door hinge adjustment 1
Effect of hinge adjustment – exagerrated for clarity
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
23
Centreline of hinge pin
Fig. 6-3
Fig. 6-4
Hide quick links:
Advertisement
Table of Contents
