Motorola Communications Gateway User Manual page 57

Introduction Before You Begin
7.6 mm maximum
10.5 mm maximum
4.0 mm
Home Print
Installation & Configuration
Wall Mounting, continued
6
If necessary, seat an anchor in each hole.
Use M5 x 38 mm (#10-16 x 1
screw head diameter of 10.5 mm to mount the Communications Gateway.
7
Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown
at left:
I
I
8
Place the Communications Gateway so the keyholes are above the mounting
screws.
9
Slide the Communications Gateway down so it stops against the top of the keyhole
opening.
X
Exit
Troubleshooting
1
/ inch) screws with a flat underside and maximum
2
There must be 4.0 mm between the wall and the underside of the screw head.
The maximum distance from the wall to the top of the screw head is 7.6 mm.
52
Communications Gateway User Guide
FAQ Glossary
License