Installation And Configuration Overview - Motorola Communications Gateway User Manual

Introduction Before You Begin
Home Print
Installation & Configuration

Installation and Configuration Overview

To install and configure your Motorola Communications Gateway, you need to:
1
Install the cables as described in one of:
I
I
2
If you are using the
in "Setting Up a USB Driver"
3
Configure TCP/IP following the instructions in
the instructions in your Macintosh or UNIX user manual.
4
Verify the IP address following one of:
I
I
I
X
Exit
Troubleshooting
"Cabling and Startup for a Single User"
"Cabling for Multiple Users" on page 43
USB Connection, set up the USB driver. Follow the instructions
on page 21. Ethernet users can skip this step.
"Verifying the IP Address in Windows 95, 98, or Me"
"Verifying the IP Address in Windows 2000 or XP"
The instructions in your Macintosh or UNIX user manual
12
Communications Gateway User Guide
FAQ Glossary
on page 13
"Configuring TCP/IP" on page 32 or
on page 40
on page 41
License