Replacing The Battery - Motorola Communications Gateway User Manual

Introduction Before You Begin
Home Print
Installation & Configuration

Replacing the Battery

When the
the battery:
Flashes yellow — the battery is low
I
Flashes red — the battery has failed
I
Lights solid red — the battery is missing
I
Caution
To replace the battery:
3
1
Unplug the power cord from the AC wall outlet to turn off AC power.
2
2
On the
left.
3
Carefully remove the battery compartment cover by lifting up about 2 to 3 cm
(1 inch) and then pulling straight out. To avoid damaging the cover, be sure you
1
1
rotate it only slightly (arrow 2) before pulling it out (arrow 3).
X
Exit
Troubleshooting
battery light on the Top and Front Panel
Replacing the battery with an incorrect type can cause an explosion. Use
a CSB GP 1222 F2 12V 2.2 Ah battery only. For information about
obtaining a spare battery, contact your service provider.
Battery Compartment cover, push in on the tabs, as shown by arrows 1 at
45
Communications Gateway User Guide
FAQ Glossary
License
does any of the following, replace