Carrier Crystal Plus 53KHFT 12 A6716511Df758830Bc5510C21C0Aa9De page 24

USE OF REMOTE CONTROL (Cont.)
TIMER OFF Function
If you want to stop automatically the air conditioner at the desired
time ( between 0 ~ 24 hrs ), use TIMER OFF function
TIMER OFF function is useful when you go to sleep.
TO SET TIMER OFF TIME
1. Press the Timer button
last Auto-off setting time and the signal " TIMER OFF " will be shown
on the LCD display area. Now it is ready to reset the Auto-off time.
2. Press the Timer button
you press the button, the time increases by half an hour between 0 and
10 hours and by one hour between 10 and 24 hours.
3. After setting the TIMER OFF, there will be a one half second delay before
the remote control transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal " TIMER OFF " will
disappear and the set temperature will re-appear on the LCD display of
the remote control.
TIMER light of appears on the display panel of the indoor unit.
TO CANCEL TIMER OFF FUNCTION
Press Timer button
EXAMPLE OF TIMER OFF SETTING
To stop automatically the air conditioner in 10 hours.
1. Press the Timer button
operation time and the signal " TIMER OFF " will show
on the display of the remote control.
2. Press the Timer button
TIMER OFF display of the remote controller.
3. Wait for 0.5 second and the TIMER OFF stops flashing and
this function is activated. The display of the remote
control will show the set temperature again.
CAUTION
When you select the timer operation, the remote control automatically transmits the TIMER OFF signal to the
indoor unit for the specified time.
Therefore, keep the remote control in a location where it can transmit the signal where it can transmit the
signal to the indoor unit properly.
The effective operation time set by the remote control for the TIMER OFF function is limited to the following
settings: 0.0, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13, 14,
15, 16, 17, 18, 19, 20, 21, 22, 23, and 24.
. The remote control shows TIMER OFF, the
again to set desired Auto-off time. Each time
until the time setting is 0.0
, the last setting of stopping
to display "23" on the
(
Set
19 )
Stop
On
10 hours later