Carrier Crystal Plus 53KHFT 12 A6716511Df758830Bc5510C21C0Aa9De page 23

USE OF REMOTE CONTROL (Cont.)
TIMER ON Function
If you want to start automatically the air conditioner at the desired
time ( between 0 ~ 24 hrs ), use TIMER ON function
TIMER ON function is useful when you wake up in the morning
or when you return home.
TO SET TIMER ON TIME
1. Press the Timer button
last Auto-on setting time and the signal " TIMER ON " will be
shown on the LCD display area. Now it is ready to reset the Auto-on
time to start the operation.
2. Press the Timer button
Each time you press the button, the time increases by half
an hour between 0 and 10 hours and by one hour between 10
and 24 hours.
3. After setting the TIMER ON, there will be a one half second delay
before the remote control transmits the signal to the air conditioner.
Then after approximately another 2 seconds, the signal " TIMER
ON " will disappear and the set temperature will re-appear on the
LCD display of the remote control.
TIMER light of
TO CANCEL TIMER ON FUNCTION
Press Timer button
EXAMPLE OF TIMER ON SETTING
To start automatically the air conditioner in 6 hours, apply the
following steps :
1. Press the Timer button
time and the signal " TIMER ON " will show on the display
of the remote control.
2. Press the Timer button
display of the remote control.
3. Wait for 0.5 second and the TIMER ON stops flashing and this
function is activated. The display of the remote control will
show the set temperature again.
CAUTION
When you select the timer operation, the remote control automatically transmits the TIMER ON signal to the
indoor unit for the specified time.
Therefore, keep the remote control in a location where it can transmit the signal to the indoor unit properly.
The effective operation time set by the remote control for the TIMER ON function is limited to the following
settings: 0.0, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13, 14,
15, 16, 17, 18, 19, 20, 21, 22, 23, and 24.
. The remote control shows TIMER ON, the
again to set desired Auto-on time.
appears on the display panel of the indoor unit.
until the time setting is 0.0
, the last setting of starting operation
to display "6.0" on the TIMER ON
Set
( 18 )
Start
Off
6 hours later