Bypass Copying On Standard Size Paper - Toshiba E-studio 200L Operator's Manual

6.BYPASS COPYING (Cont.)

Bypass Copying on Standard Size Paper

1
Place paper on the bypass tray, and then
align the guides with the size of the paper.
- When adjusting the width of the side guide, while holding down
2
the knob of the side guide, slide the side guide.
- "Ready for bypass feeding" appears.
- Acceptable paper type for bypass copy "Acceptable Copy Paper
Types and Sizes"
- Place the paper with the side to be copied facing down.
- If you put several sheets on the bypass tray at a time, fan the
paper well before placing it.
- Place the paper so as not to exceed the line indicated on the
guides.
- Do not push the paper forcibly into the entrance of bypass
feeding. It may cause a paper jam.
- Draw the triple paper holder depending on the paper size.
- Raise (B) before placing LD/A3 size or larger.
2
Place the original(s).
3
Press the button that represents the size
of the paper that has been set for LD, LG,
LT and ST-R.
When the paper size is not specified, the copying speed may be
lower due to the cleaning operation inside the copier.
62
2.HOW TO MAKE COPIES
Page 35
( B )