Toshiba E-studio 200L Operator's Manual page 213

Hide thumbs Also See for E-studio 200L:
Table of Contents

Advertisement

Error Code
1C6D
System error
1C70
SMTP client OFF
1C80
Internet Fax transmission failure when
processing E-mail job received
1C81
Onramp Gateway transmission failure
1C82
Internet Fax transmission failure when
processing Fax job received
1CC0
Job canceling
1CC1
Power failure
3A10-3A12
MIME format error
3A20-22
E-mail process error
3A30
Partial E-mail timeout error
3A40
Invalid partial E-mail received
3A50-3A52
HDD full error
3A60-3A62
HDD full alert
3A70
Interrupt partial E-mail reception
3A80-3A82
Partial E-mail disabled
3B10-3B12
E-mail format error
Cause & Message
Corrective Action
Turn the power OFF and then back ON.
Perform the job in error again. If the error still
occurs, contact your service representative.
Ask your administrator to enable the SMTP
Client and perform the job again.
Confirm the "Received Internet Fax Forward"
settings.
Confirm the mail box settings.
Confirm the "Received Fax Forward" setting.
Job was canceled
Check if the power cable is connected
properly and it is inserted securely. Check if
the power voltage is unstable.
Ask the sender to resend the E-mail in the
MIME1.0 format.
Ask the sender to resend the E-mail.
Ask the sender to resend the E-mail, or
change the Partial Wait time setting.
Ask the sender to resend the partial E-mail in
the RFC2046 format.
Ask the sender to resend the E-mail by
separating it to several E-mails. If this error
occurs because the paper empty occurs and
too much waiting jobs are stored in the hard
disk, add the paper to activate other jobs.
Ask the sender to resend the E-mail by
separating it to several E-mails. If this error
occurs because the paper empty occurs and
too much waiting jobs are stored in the hard
disk, add the paper to activate other jobs.
Ask your administrator to enable the Enable
Partial E-mail setting and ask the sender to
resend the E-mail.
Ask your administrator to enable the Enable
Partial E-mail setting and ask the sender to
resend the E-mail.
Ask your administrator to enable the Enable
Partial E-mail setting and ask the sender to
resend the E-mail.
9
211

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio 230E-studio 280

Table of Contents