Trouble Shooting - Emerson CURVA CF244BS00 Owner's Manual

!
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLE SHOOTING YOUR FAN.
TROUBLE
1. Fan will not 1. Fuse or circuit breaker blown.
start.
2. Loose power line connections to
the fan.
3. Fan/Light Remote Control is OFF.
1. Blades not attached to fan.
2. Fan sounds
noisy.
2. Screws securing fan blades to motor
are loose.
3. Loose screws in motor housing.
1. Setscrews in motor coupling are
3. Fan wobbles
not tightened securely.
excessively.
2. Setscrew in the hanger ball/downrod
assembly is loose.
3. Screws securing fan blades to motor
are loose.
4. Fan blades are not seated properly.
5. Hanger bracket and/or ceiling
outlet box is not securely fastened.
6. Fan blades out of balance.
4. Both lamps will 1. Loose electrical connectors.
not illuminate.
2. Remote control battery is weak.
3. The lamps are burnt out.
4. Lamps turn on and then turn off.

Trouble Shooting

PROBABLE CAUSE
13
SUGGESTED REMEDY
1. Check main and branch circuit fuses or
circuit breakers.
WARNING: Make sure main power is
!
turned off.
2. Check line power connections to fan.
3. Turn ON Fan/Light Remote Control.
1. Attach blades to fan before operating.
2. Check to make sure the screws which attach
the blades to the motor are tight.
WARNING: Make sure main power is
!
turned off.
3. Check to make sure all screws in motor housing
are snug (not over-tight).
1. Raise coupling cover and tighten setscrews
securely.
2. Tighten the setscrew in the hanger ball/
downrod assembly.
3. Check to be sure screws which attach the fan
blade to the motor are tight.
4. Check to be sure that the screws securing
the fan blades seat firmly.
5. Tighten the hanger bracket screws to the outlet
box, and/or secure outlet box.
6. Interchanging an adjacent (side by-side) blade
pair can redistribute the weight and
result in smoother operation. Or use supplied
balancing kit to balance blades.
1. Shut off the branch circuit electricity at the
fuse box or breaker panel and check the
receiver electrical connectors for proper
installation.
2. Replace the AAA remote batteries.
3. Turn the electricity off and replace the lamps
with new 50W max. lamps.
4. The built in circuit breaker is tripping, check that
the lamps are each 50W maximum.
CAUTION: Turn the lights off before touching
halogen lamps, they are very hot and can
burn your fingers.
Please contact 1-800-654-3545 for further assistance
emersonfans.com
U.L. Model No.: CF244 & CF252