How To Hang Your Ceiling Fan - Emerson CURVA CF244BS00 Owner's Manual

Hide thumbs Also See for CURVA CF244BS00:

Owner's manual (21 pages)

Owner's manual (24 pages)

Table Of Contents

Table of Contents

WARNING

The fan must be hung with at least 7' of clearance from

floor to blades (Figure 9).

WARNING

The outlet box and joist must be securely mounted and

capable of supporting at least 50 lbs. Use only a U.L.

outlet box listed as "Acceptable for Fan Support of

22.7 kg. (50 lbs.) or less".

WARNING

To reduce the risk of fire, electric shock, or personal

injury, mount fan to outlet box marked "Acceptable for

Fan Support of 22.7 kg. (50 lbs.) or less", and use

screws supplied with outlet box. Most outlet boxes

commonly used for support of light fixtures are not

acceptable for fan support and may need to be

replaced. Consult a qualified electrician if in doubt.

1. Disconnect electrical power to the branch circuit at

the circuit breaker or fuse box before attempting to

install the ceiling fan mounting plate on the outlet

box.

WARNING

Turning off wall switch is not sufficient. To avoid

possible electrical shock, be sure electricity is turned

off at the main fuse box before wiring. All wiring must

be in accordance with National and Local codes and

the ceiling fan must be properly grounded as a

precaution against possible electrical shock.

2. Securely attach the hanger bracket to the outlet box

using the two screws supplied with the outlet box

(Figure 10).

3. Carefully lift the fan and seat the hanger ball/downrod

assembly on the hanger bracket that was just

attached to the outlet box (Figure 11). Be sure the

groove in the ball is lined up with the tab on the

hanger bracket (Figure 10).

WARNING

Hanger bracket must seat firmly against outlet box. If

the outlet box is recessed, remove wall board until

bracket contacts box. If bracket and/or outlet box are

not securely attached, the fan could wobble or fall.

WARNING

Failure to seat tab in groove could cause damage to

electrical wires and possible shock or fire hazard.