Table of Contents
Advertisement
General Precautions
• Read the WET CONDITIONS MAINTENANCE
procedures and make sure that you have all the tools
you will need to properly maintain your boat.
• Not all batteries can be used in wet conditions. Consult
the battery manufacturer before use. Caution should be
taken when using Li-Po batteries in wet conditions.
• Most transmitters are not water-resistant. Consult
your transmitter's manual or the manufacturer before
operation.
• Never operate your transmitter or boat when lightning is
present.
• Salt water is very conductive and highly corrosive. If
you choose to run your boat in salt water, immediately
rinse the boat in fresh water after each use. Operating
your boat in salt water is at the sole discretion of the
modeler.
Wet Conditions Maintenance
• Drain any water that has collected in the hull by
removing the drain plug or canopy and tilting the boat in
the appropriate direction to drain the water.
Table of Contents
Transmitter Controls ...................................................... 4
Transmitter Battery Installation .................................... 4
Antenna Tube Installation .............................................. 4
Battery Pack Installation ................................................ 5
Range Check ................................................................... 5
Getting Started ............................................................... 6
When You Are Finished ................................................. 6
Boating Tips .................................................................... 6
Strut Angle Adjustment ................................................. 7
Maintenance ................................................................... 8
Drivetrain Lubrication..................................................... 8
Propeller Service ........................................................... 8
Water Cooling System ................................................... 8
General Information ...................................................... 9
Binding ......................................................................... 9
Throttle Range Calibration ............................................. 9
Failsafe ......................................................................... 9
Low Voltage Cutoff (LVC) ............................................... 9
Electronic Speed Control (ESC) Programming .............. 9
ESC Programming Procedure .......................................10
Troubleshooting Guide ............................................... 10
LIMITED WARRANTY ....................................................11
Contact Information .................................................... 12
EU Compliance Statement .......................................... 12
Replacement Parts ....................................................... 46
Optional Parts .............................................................. 46
Zelos™ Twin 36
CAUTION: Always keep hands, fingers, tools and
any loose or hanging objects away from rotating
parts.
• Remove the battery pack(s) and dry the contacts. If
you have an air compressor or a can of compressed air,
blow out any water that may be inside the recessed
connector housings.
• Remove all moving parts. Dry and lubricate parts after
every 30 minutes of operation or if the boat becomes
submerged.
NOTICE: Never use a pressure washer to clean your boat.
• Use an air compressor or a can of compressed air to
dry the boat and help remove any water that may have
gotten into small crevices or corners.
• Spray the bearings, fasteners and other metal parts with
a water-displacing light oil or lubricant.
• Let the boat air dry before you store it. Water (and oil)
may continue to drip for a few hours.
Specifications
Length
36 in (914.4mm)
Beam (width)
12.67 in (322mm)
Hull Material
Fiberglass
(2) Dynamite
Motor
(2) Dynamite 120A BL Marine
ESC
Transmitter
Spektrum
Receiver
Spektrum
Batteries
(2) 7.4V 50C LiPos (sold separately)
(2) 11.1V 50C LiPos (sold separately)
are required to operate the boat.
(4) AA batteries (sold separately) are
required to operate the transmitter.
36in (914.4mm)
12.67 in
(298.4mm)
®
6-Pole Marine (2000Kv)
DX2E
™
SR310 3-Channel
™
EN
3
Advertisement
Table of Contents
