Sending Discrete Power O N And Off - Dish Network ViP622 User Manual

• On a remote TV, RECOVER must be programmed to tune your remote TV to the
specific channel to receive TV2 programming (for example, channel 60), using the
instructions on page 88.
Note: Press any remote-control button other than RECOVER to end this procedure.
Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to
tune your TV to channel 3, then channel 4, and then other video inputs with each press of
RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV
video. If RECOVER is programmed to a specific channel (see page 88), RECOVER will
tune the TV to the specific channel (for example, channel 60).
Removing the Recover Button Channel Programming
The following instructions describe how to reset RECOVER to restore satellite TV viewing
by tuning your TV (or VCR) to channel 3, 4, and other inputs.
S D
ENDING ISCRETE
Installers use remote control discrete power on and power off IR commands when
programming macro commands into universal remotes. Using an on-only or off-only
command is more effective than a toggle on/off command when trying to make sure the
Sending Discrete Power On and Off
P O
OWER N AND
Remote Controls
O
FF
89