Dish Network ViP622 User Manual page 89

Chapter 10
Controlling Other Components
3
Press VOLUME UP to enable SAT Auto-Tune or VOLUME DOWN to disable the feature.
4
Press the POUND (#) button on the remote control.
Removing the SAT Auto-Tune Channel
1
Press and hold the TV mode button for several seconds until it stays lit.
2
Press the STAR (*) button on the remote control.
3
Enter the digits 00 or 000 using the NUMBER PAD.
4
Press the POUND (#) button on the remote control.
Using SAT Auto-Tune with a VCR
If you have a VCR connected to the remote TV. as described in Connecting a VCR to the
Remote TV, then you can use the SAT Auto-Tune feature with the VCR tuner.
Make sure the remote control has been programmed to operate your VCR (in DVD mode,
not in the AUX device mode), and then follow the instructions for Setting a SAT Auto-Tune
Channel on page 79. In these instructions, use the DVD/VCR mode instead of TV mode.
Likewise, you may follow the instructions for Removing the SAT Auto-Tune Channel,
except use the DVD/VCR mode button instead of the TV mode button in the first step.
Combination Devices
If you are programming the remote to control a combination device, such as a TV/VCR or
a TV/DVD, program the remote control in one mode (TV), and then repeat the procedure
in the other mode. For example, to program the remote to control a TV/VCR using codes
622 815, follow the instructions to program the remote in TV mode using code 622, and
then repeat the instructions to program in DVD mode to control the VCR using code 815.
80