Dish Network ViP622 User Manual page 26

Remote Control Batteries
The remote control comes with four AAA-sized batteries. When you replace
old batteries, you should replace all the batteries. Use batteries of the same
type, for example, all alkaline or carbon zinc. Don't mix batteries of different
chemistries. Alkaline batteries last longer than carbon zinc.
1
Press down on the top of the battery cover and slide the cover off.
2
Take out all old batteries.
3
Put new batteries in. Make sure you match the plus ("+") ends with the plus
markings on the battery case.
4
Slide the cover back into place.
Low Battery Warning
When you see a low-battery warning message on your screen just below the top Program
Banner, the batteries in your remote control are weak and need to be replaced.
Whi White te Waters Wat
TUE TUE 3/19 3/ 1
6:00 p 6:0 0 pm -
6:2 2 5 5 p pm
3 30 1 HBO2
Remote Battery Low
Attach the Remote Antenna
Attach the remote-control antenna to the receiver's back panel R
jack so that you can use your UHF Pro Remote Control 2. Without the remote-control
antenna properly attached, you cannot use the UHF Pro remote to control the receiver.
See Adjusting the Remote Control Antenna on page 76 for more detailed information
about improving the performance of your UHF Pro Remote Control 2.
NR
9:30 pm m Time L Tim e Left e : 2:05 :05
2 E E Lis List: t: Fam F F F am m ily il
Satellite Receiver
Remote Control
Remote Battery Low
A
EMOTE NTENNA
input
17