Dish Network ViP622 User Manual page 114

YPbPr Connections
The YP P (component) connections provide high-quality video to your HDTV or HD
B R
monitor. If an HDMI audio/video connection between your receiver and nearby TV is
unavailable or not applicable, then you should use component video with separate audio.
1
Connect receiver
and monitor with
YPbPr Component
connections
1
Connect between the YP
nearby TV using component (usually red/green/blue) video cables.
2
Connect audio (red and white) RCA-type cables between the receiver A
audio input connections that go with the YPbPr connectors on your HDTV or monitor.
3
If you do not see a picture, change the resolution setting on the receiver. Use the steps
below and Setting Up to Display in HD on the next page.
4
Turn up the volume on your HDTV and confirm you have sound. Check the RCA-type
connections if you don't have sound.
No Picture on the Nearby TV
This section will help you make a picture appear on the nearby TV in case you could not
do so in the previous sections.
1
Connect the three RCA-type cable connections (yellow for video and red/white for audio)
between the receiver TV1 O
2
Make sure that both the receiver and nearby TV are turned on (not in standby or power-
saving mode).
3
Make sure the nearby TV is set to view the RCA-type audio/video inputs or source. Look
on the back of your HDTV or consult your HDTV user's guide for more information.
4
Change the receiver's HDTV settings, as described on page 106.
5
Switch to the nearby TV to display from the HD inputs (HDMI or component video) that
you selected in the previous sections. If you have a picture from TV1, you are finished.
6
Repeat steps 4 and 5 until the nearby TV displays a video image from the receiver.
2
Connect receiver and
monitor with Audio cables
P component video connections on the receiver and the
B R
and the nearby TV.
UT
Connections and Setup
Connecting to the Nearby TV (TV1)
L
3
R
AUDIO
Turn monitor
and receiver on
sound and
and confirm
picture
O
UDIO UTPUTS
4
Confirm
volume
and
105