Inactivity Standby - Dish Network ViP622 User Manual

Chapter 11

Inactivity Standby

I
NACTIVITY
If your receiver is on for a preset period of time without any activity (for example, no
channel changes or use of DVR controls), the Inactivity Standby feature turns off the
receiver so that you'll always have the latest Program Guide and DISH On Demand (if
available on your model). Enabling this feature is recommended and can also improve the
reliability of your receiver. To change the settings for this feature, complete the following:
1
Press the MENU button. Select Preferences, and then Inactivity Standby.
2
Highlight Activation and use the UP and DOWN ARROW buttons to switch between
Enabled and Disabled, as applicable.
3
Highlight Inactivity Duration and use the UP and DOWN ARROW buttons to select the
amount of time the receiver waits before turning off.
4
Select Done.
Note: Select Defaults to reset any changes you have made to this feature.
T
IPS
• To take full advantage of Dolby Digital 5.1 surround sound, you need a digital optical
audio cable and audio equipment that supports this feature.
• To use the Caller ID feature on this receiver, be sure to have the receiver connected to
an active phone line and have Caller ID service from your phone company.
Q
UESTIONS
• How can I see who has called me in the past? Open your Caller ID History by
pressing the MENU button, selecting System Setup, and then Caller ID History.
• Why is my audio in another language? An alternate language may have been
selected. See the instructions on page 98 to change your preferred language.
• How can I change the channel order in the Program Guide? You can switch from
ascending order (lowest numbered to highest) to descending order (highest numbered
to lowest) or back, by following the instructions on page 96.
102
S
TANDBY