Connecting Cables; Connecting Usb2.0 Interface Cable - MIMAKI JFX200-2513 Operation Manual

Connecting Cables

Connecting USB2.0 Interface Cable

Connect the PC and this machine with the USB2.0 interface cable.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our office when the USB2.0 interface is not attached to the
PC.
USB cable
Notes on USB 2.0 Interface
• Your RIP must be compatible with USB 2.0.
 When two or more JFX200 machines are connected to one personal computer
When two or more JFX200 machines are connected to one personal computer, the personal computer may not
recognize all the JFX200 machines normally.
Reconnect the unrecognized JFX200 machine to another USB port, if available, and check to see if it is
recognized.If the JFX200 machine is not recognized by the newly connected USB port, use USB 2.0 repeater
cables available on the market. (However, keep the distance between the JFX200 and the personal computer
within 20 m.)
 Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is connected to
the same personal computer that a JFX200 machine is connected to, the USB device may not be recognized.
When JFX200 is connected to the personal computer to which an external HDD is connected via USB, the
speed of data output to JFX200 may drop.That can cause the head unit to stop temporarily at the right or left
end during printing.
Use a USB cable that is less than 5 m. If it is necessary to use one that is 5 m or longer, use a commercially
available USB 2.0 repeater cable.
Use a USB cable that is less than 5 m.
USB 2.0 repeater cable
1
3
4
5
6
1-7