Fm & Fm-Stereo Reception; Preset Radio Stations - Jensen JiTS-300i User Manual

button on the remote repeatedly. Use the manual tuning method to tune to weaker
stations that are bypassed during Automatic Tuning.
4. To automatically tune to the next radio station with the strongest signal, press and
hold the /
to scan and then release the button. The tuner will stop scanning when it receives
the next strongest station signal.
5. You can also direct enter the radio station frequency via numeric buttons on the
remote control. For example, press buttons 8, 9 and 8 then wait for few seconds to
get to 89.8 MHz. If entered frequency is invalid (out of range), "ERROR" message
will display on the screen.
6. Press the VOLUME+/- button to adjust the volume control to the desired level.
7. If necessary, press the TREBLE or BASS
adjust treble or bass effect to the desired level.
8. When listening to radio, you can press the TIME button on the remote control to
check the current time. It will display the time for few seconds and then return to
display radio station frequency.
FM & FM-STEREO RECEPTION
Press the REPEAT/ST button on the remote control to switch between FM STEREO
and FM MONO modes.
Set the FM reception to "MONO", stations will be received in MONO mode. When
an FM station is weak or distorted, listening is usually improved by switching the FM
reception to MONO mode.
Set the FM mode to the "STEREO" to receive stereo broadcasts. The "STEREO"
indicator will show in LCD display to show an FM stereo station is detected.
HINTS FOR BEST RECEPTION:
The receiver has a build-in FM wire antenna, slightly rotate the unit or reposition for the
best reception.
NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so
weak stations may be skipped. You can manually tune to find the weak stations
if a station gets skipped. With strong signals, the tuner may stop before it
reaches the actual broadcast frequency, so you may need to manually tune for
the best reception.

PRESET RADIO STATIONS

This unit has 20 preset memories for the FM radio.
1. Press the POWER button to turn on the unit.
2. Press the SOURCE button to select TUNER mode.
3. Tune to the desired radio station either by "manually" or "automatically" tuning
button for 1-2 seconds until frequency readout on the display begins
/ button on the remote control to
4