Care And Maintenance - Jensen JIMS-125I User Manual

3. Turn on the external audio device.
4. To select auxiliary audio input, press the FUNCTION button to select AUX mode.
5. The volume level can now be controlled through the main unit. Operate all other
functions on the auxiliary device as usual.
NOTE:
If you connect this unit to the Line-Out Jack of your external device then you only

need to adjust the volume control of this unit. If you connected the Headphone
Jack of your external device then you may need to adjust both the volume control
of your external device and the volume control of this unit to find the most
desirable volume setting.
Press the POWER button to turning off the unit when you finish listening. Don't

forget to switch off the power of your external device as well.
If the system does not respond or exhibits erratic or intermittent operation, you may
have experienced an electrostatic discharge (ESD) or a power surge that triggered the
internal microcontroller to shut down automatically. If this occurs, simply disconnect
the AC adaptor and remove the system backup battery, wait for at least 3 minutes and
then setup the unit again as if it is a brand new unit.
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such
as fluorescent lamps or motors.
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect your unit from the AC power source

when cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other

furniture, Use caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax

or polish sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned

with a soft cloth slightly dampened with a mild soap and water solution. Never use
abrasive cloths or polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
RESETTING

CARE AND MAINTENANCE

6