Snorkel S3370BE Parts & Service Manual page 25

MACHINE SETUP:
CHANGE DEFAULTS
9. Press [ENTER]
The display screen will show:
DEFAULTS:
1=SR2770
10. Only one machine type at a time will show on
the screen.
Use the [UP & DOWN ARROWS] to select
the correct machine type (the full list is
shown below).
0=MHP
1=SR2770
2=SR3370
3=SR3370eu
4=SR2255
5=SR2755
DANGER
Death or personal injury and serious
damage to the machine can result from
selecting the incorrect machine type.
ENSURE that the machine type you selected
at the above step is the one you are carrying
out the auto level calibration on.
11. Press [ESC]
The display screen will show:
MACHINE SETUP:
CHANGE DEFAULTS
12. Press the [RIGHT ARROW] to select the
calibrate level function.
The display screen will show:
MACHINE SETUP:
CALIBRATE LEVEL
13. Press [ENTER].
The display screen will show:
SR3370 & SR2770 – 13184B
Maintenance Information
CALIBRATE LEVEL:
YES:ENTER.NO:ESC
14. Press [ESC] to abort the calibration or
[ENTER] to proceed with the calibration
process.
If [ENTER] is selected the display screen
should show:
CALIBRATE LEVEL:
TILT 0.0'.0.O'
15. Values should now read approximately 0.0,
0.0. If they do not repeat from step 9.
16. Switch the ignition off and on again.
17. Check that the machine now levels correctly.
Rev D page 21