Black & Decker spacemaker tros1000d Use & Care Manual page 10

10. Wipe dust and debris off the topside and underside of the cabinet
surface.
11. Place a washer inside the cabinet over
each of the 4 holes you drilled.
12. Now, use your ruler or the paper ruler
provided to measure the overhang
molding height, placing your ruler vertically
against the underside of the cabinet
behind the overhang molding. This number
determines the number of spacers you
need, using a number of spacers equal to
the overhang molding height. For example,
a 1" overhang molding would use 2,
spacers on each of the rear holes (L).
13. Drop one of your screws through each of the washers covering the
holes in the cabinet, from inside the cabinet down.
Note: To determine which screws to use, you must have enough of the screw
exposed underneath the cabinet to properly thread the screw into the nut.
14. Place the appropriate number of spacers determined in step 12 on
both of the rear screws so the appliance will be even (M).
Note: If the height of your overhang molding
is too tall to be accommodated by the number
of spacers provided, you may call, toll-free, at
1-800-231-9786 to order additional spacers at
no charge.
Note: For spacer installation, you may require
assistance in order to hold spacers in place
while securing the appliance at the same time.
If assistance is not available, use a small clamp
to hold the spacers in place while you position
the appliance.
15. Once spacers are set, hold hood up and tighten screws to secure.
Screw from inside the cabinet down.
Note: Always tighten screws to ensure the appliance does not move or
shake during operation.
16. After the hood is secured, lift the toaster oven up to mount. Hook the
mounting tabs on the back of the oven over the mounting hooks at
the back of the hood (see Illustration F).
17. Once the back hooks are secure, hook your fingers around the feet
on the front of the toaster oven (see Illustration G). Pull forward and
push up on the feet at the same time to engage the front hooks.
18. Plug into standard electrical outlet. Extra cord can be hung over cord
management hook behind unit (see Illustration H).
Warning: Risk of electrical shock and fire. Do not allow cord to touch
rear surface of oven.
Caution: This appliance features a Save-A-Plug™ outlet receptacle to
connect smaller †SpaceMaker™ appliances such as the can opener. Do
not use this outlet for any other appliance!
Note: If you are connecting another †SpaceMaker™ appliance into the Save-A-
Plug™ outlet, make sure you can easily unplug the appliance after each use.
19. Your †SpaceMaker™ appliance is now ready for use!
L
⁄ "
1
2
M
10