Safety Notice; Repeating Symbols - Rotax MMH-912 Series Maintenance Manual

7) Safety notice

Although the mere reading of such information does not eliminate the hazard, your
understanding and application of the information will promote correct use.
The information and components/system descriptions contained in this Maintenance
Manual are correct at the time of publication. BRP-Rotax maintains a policy of
continuous improvement of its products, without, however, incurring any obligation to
install them on its products previously manufactured.
BRP-Rotax reserves the right to discontinue or alter any specification, design, detail,
model or equipment, at any time and without incurring obligation.
The illustrations in this Maintenance Manual show the typical construction. They may
not correspond to every detail or the exact shape of the actual parts, but show parts
which have the same or similar function.
Specifications are given in the SI metric system with the USA equivalent in parenthesis.
7.1)

Repeating symbols

This Manual uses the following symbols to emphasize particular information.
These indications are important and must be respected.
▲ WARNING: identifies an instruction which, if not followed, may cause
■ CAUTION: Denotes an instruction which, if not followed, may severely
◆ NOTE:
XXX
4
VT06
Effectivity 912/914 Series
Edition 1 / Rev. 3
BRP-Powertrain
Maintenance Manual
serious injury including the possibility of death.
damage the engine or other component.
Indicates supplementary information which may be needed
to fully complete or understand an instruction.
A revision bar outside of the page margin indicates a change to
text or graphic.
In various illustrations, this symbol indicates the location of the
serial number on a component.
In the illustrations concerned, this symbol indicates the position
of the serial component number (e.g. on crankshafts, cam-
shafts).
In the illustrations concerned, a fourdigit combination of letters
and numbers indicates a control point which needs to be
checked. See the corresponding dimension sheets for the
correct value.
00-00-00
page 25
October 01/2010