Edition 1 / Rev - Rotax MMH-912 Series Maintenance Manual

3.15) Pushrods
See Fig. 72-98.
Clean push-rods (1) and carry out a visual inspection. Make sure that the two
ball heads (2) pressed into the rod fit tightly. Excessive engine speed may have
caused bending of the pushrods. Roll push-rods and check for run out,
dimension (VT09). Lube oil from the hydraulic valve tappet passes to the rocker
arm through the bore (3).
See 72-00-00 sec. 4.
Fig. 72-98
2
Effectivity 912/914 Series

Edition 1 / Rev. 0

BRP-Rotax
Maintenance Manual
1
~160 mm
(6.30 in.)
2
07417
72-00-00
May 01/2007
3
page 85