Ricoh FT5034C Service Manual page 242

Support
Shaft
Stopper
Collar
Bin Support Rack
[Front Side]
4. Remove the bin drive motor assembly (3 screws).
5. Remove the rear bracket (4 screws).
6. Remove the front bracket (5 screws).
7. Remove the front and rear bin support pinion gears.
8. Remove the front and rear safety levers (1 screw each).
9. Move the front and rear bin support racks off the gears.
10. Remove the front and rear middle gears.
11. Remove the front and rear drive gears (1 E-ring each).
NOTE: Be careful not to lose the pins.
12. Remove the front and rear transfer wheels.
13. Remove the 2 support shafts (2 screws each).
14. Remove the 2 stopper collars (1 screw each).
15. Lift up the bins along the bin guide slots and take them out from the sorter one by
one.
16. Apply Grease G501 on the pins of the new bins and reassemble the sorter.
•
NOTE: Only the top bin has mylars at the bin entrance.
•
When installing the drive gears on the shaft, make sure that the
dot-marked tooth of the drive gear engages with the dot-marked teeth
of the transfer wheel as shown.
•
When tightening the bin support rack to the safety lever, keep a small
gap between the rack and the lever for smooth movement.
Safety
Lever
Drive Gear
Middle Gear
Bin Support
Pinion Gear
- 15 -
Front Bracket
Transfer Wheel
Bin